Security Company Near Athens

Repaired Elevator Camera.

Service Ticket #4011 performed on 9/11/24 Technician arrived onsite and called Daniel. Daniel told the Technician that both Employee Gate Intercoms were not opening Gates on either side. Technician tested the cables going to the Switch and both the Intercoms were good. The Entry Gate Intercom was not coming on and will need to be replaced. The Exit Gate Intercom was on, but would not change the Relay state when prompted to unlock, this will also need to be replaced. Technician spoke with Tech Support and they verified that it most likely needed to be replaced. Technician powered off the Gate Operators in the open state and had to leave the doors off next to the side. Technician had the Maintenance Team open the Gate and the Technician let the site know before leaving to close it. Technician updated Daniel before departure.

Project Description: K9 installed all Low Voltage Devices according to CoffeeWow project plans provided by Dodge. K9 ran cabling to the 2 Temp Sensors, 1 HVAC Control Module, 2 CAT6 Data Drops, and 1 Zone Expander for each store number listed. Cabling Includes CAT6, 18/4, and 22/4 All Devices provided by Advance Alarms

Service Ticket #3102 performed on 8/7/24 Technician arrived onsite and found the Surface Mounted Strike that was not working but the scan was. Technician traced the wire down to the Panel and troubleshooted the MR52 Board where the cable was landed and found the issue was with the Input and Output of the Power Supply. Technician switched the wires over to open the ports on the second Power Supply and the Strike started working again. System was working properly upon completion.

Service Ticket #3063 performed on 7/23/24 Technician arrived onsite and checked out the five Cameras that were offline. Technician found that the Switch had been turned off. Technician got all five of those Cameras to come back up and showed them online. Technician checked out the two Elevator Cameras and it seemed like they were conflicting with each other. When the Technician went to take one of the Cameras down, the building lost power for the second time and the Elevators shut down. Knine will need to return later to work on the two Elevator Cameras once the power is restored properly.

Project Description: K9AS installed the QT PPD Hardware and cabling according to drawings provided by Advanced Alarms.

Technician arrived at store 1726, UPS is online and confirmed by radius.

Technician arrived at store 1728, UPS is online. Confirmed by radius.

Technician installed two relays and called service center and confirmed that everything is working properly. No parts were needed for this store.

Knine connected power wire to the Rex that wasn't connected years ago when a conversion was done. Tested door and everything is working properly.

Knine installed a new security system in the server room with 1 door contact and 1 motion detector. Knine will be handling the monitoring with cellular and IP. Knine replaced the server room access control that was removed during remodeling. Knine was also able to remove the reader and strike from the old server room and use it on the new one.